EGE 30 FEATURES:
DIMENSIONS :
Length overall : 9.35 m.
Engine: 15 hp.
Length of hull : 9.10 m.
Diesel tanks : 90 lt.
Length of waterline : 8.40 m
Water tanks : 120 lt.
Beam : 3.10 m.
Black, gray water tanks : 60 lt + 40 lt.
Draft : 1.60 m.
Sail Area : 47.20 m2.
Displacement :4200 kg.
Main Sail : 22.00 m2.
Ballast : 1600 kg.
Furling Cenoa : 25.00 m2.
Berths : 4-6 person
Spinnaker : 69.00 m2.
CONSTRUCTION :
Hull : Hand made solid laminate GRP mat and rowing .
Deck : Deck is moulded GRP,
stress areas where winches, sheet tracks, etc, are
reinforced by using backing chrome plates.
Ballast : 1600 kg. cast iron, torpedo shaped bottom, end
keel bolts are of stainless steel.
Rudder : Glass fibre rudder on solid stainless steel stock
(diam 40 mm.)
Rudder trunk stock is screwed to the skeg on the hull with
delrin housings.
Motor bed : Glass fibre bed moulded to the hull.
Chain plates : Stainless steel fixed on the hull.
Teak cockpit : Teak cockpit is laid from 10 mm. First class
teak ribs bonded to the deck with epoxy resin and secured by
stainless steel screws.
Expansion joints sealed by special polyurethane silicone
(Sika).
Interior joinery : Marine grade water proof plywood faced
with selected mahogany or american cherry is used in all
bulkheads and major joinery. Specially selected solid
mahogany or beech in frames and doors. Marine plywood in
bottoms, shelves, etc. where not visible. All main bulkheads
bonded to hull and deck using glass mat and polyester.
Ceiling, top sides and visible hull sides padded with foam
backed vinyl. Hullsides, bottom, bilge, etc, topcoated
throughout the interior. Varnished cabin sole, mahogany with
ashtree inlaid wood stripes.
ACCOMODATION :
Forward cabin : Double berth , stowage under the berth ,
shelves along hullsides sb and port.
Saloon : Settee on both sides. Table with fixed middle
section and folding wings. Stowage behind settee on both
sides.
Toilet compartment : GRP wash unit. Lockers along hullside,
moulded bottom section drained by electric pump.
Galley : -L- shaped galley with ice-box with 12 v Danfoss
compressor, double sink, drawer section, dry food locker,
double overhead cupboards. Two burner gas stove. The ice-box
is drained.
Navigation area : Navigation table with stowage for charts
etc. Electrical master panel mounted in bulkhead locker,
navigation seat.
Aft cabin : On SB side with double berth and wardrobe.
Shelves along hulside, stowage under the berth .
DECK EQUIPMENT :
-2 hatches , size 41
-3 portlights 20 x 40
-4 portlights 20 x 65
-1 x 16 STA Harken winch , 2 x 16 STA Harken winches
- One organiser with 3 sheaves and triple rope clutch
-4 mooring bollards,
-2 aluminium genoa tracks with rails.
-1 main sheet track with slider and tag lines.
-Navigation lights.
-25 mm. dia. Stainless steel pullpit, pushpit and ladder.
-800W Electric anchor winch.
-Solimar brand pedestal and stainless steel steering with
leather cover, compass and acceleration lever fitted on the
pedestal. (Optional Extra)
General; Bolts, nuts, washers and screws used for fastening
deck equipment are of stainless steel. Sealing used between
deck and equipment is polyurethane, silicone or specially
developed material.
INTERIOR EQUIPMENT :
Fresh water system : 120 liters water capacity GRP tank.
Pressurised water. Filler line from deck. Tanks are
ventilated. Double sink in kitchen one is drained through
hull and other to the waste water tanks. Waste water tanks
and drainage with pump. (Hot water is optional extra.)
12 volt bilge-pump and manuel emergency pump in cockpit.
Toilet installation : Hand operated marine toilet with sea
water intake directly wastes to black water tanks. Black
water tank empty through the hull by valve. (Electric toilet
is optional extra.)
Cushions : Cushions in high quality foam with first class
upholstery in choice of colours.
Electrical installation : Switchboard and control panel in
navigators area. 2 reading lights in forward cabin,
1 spot light in toilet, 4 spotlights in main cabin, 2 spot
light and 1 reading light in aft cabin, 2 x 90 amp.hrs
marine batteries, 1 both contactor.
Gas system : 1 small gas bottle ( 4,95 liters - 2,5kg.)
installed in separate, drained compartment on deck.
Reduction valve for low pressure system. 2 burner gas stove.
General Hardware : Doors have marine locks. Locker doors
have brass push locks and are hinged
with chromium plated brass hinges.
General : Bolts, nuts, washers and screws are generally
stainless steel. Hose clamps are all stainless steel.
Through bottom fittings and other piping fittings are brass.
Hoses are reinforced flexible pvc polyethylene.
ENGINE INSTALLATION :
Engine : 15 Hp. Yanmar Sail Drive diesel motor .
Controls : Lever controller and instrument panel in cockpit.
Fuel : 90 litres diesel tank in stainless steel with level
meter. Filling from deck.
Engine housing : Easily removed engine room cover with
interior joinery finish, well insulated with foam.
Battery : 2 x 90 amp.hrs battery with both contactor.
MAST AND RIGGING :
Main mast : Selden brand 12 m. long. Furler mast with two
levels of spreaders, boom and
boomvang. Cenoa furler.
Standing rigging : All stays and shrouds in stainles steel
wire.
Running rigging : 1 main halyard, 1 cenoa halyard, 1 main
sheet, 2 jib sheets.
Sails : 1 main sail, 1 furling genoa , sail bags.
ELECTRONIC:
Autohelm brand, ST 40 deep sounder and speed indicator.
STANDART EQUIPMENT :
2 Mooring lines
4 Fenders
1 Anchor with chain
1 Instruction manual.
|