EGE 35 DS SPECIFICATIONS:DIMENSIONS :
Length overall : 10.60 m.
Length of waterline : 9.25 m.
Beam : 3.50 m.
Draft : 1.70 m.
Displacement : 6.100 kg.
Ballast : 1.900 kg.
Sail Area: 61.70 m2
Headroom: 1.95 m.
Cabins: 2
Berths: 4-5
Toilets: 1
Fuel Tanks: 120 lt.
Water Tanks: 220 lt.
Power: 30 hp
CONSTRUCTION :
Hull : Hand made solid laminate GRP mat and rowing .
Deck : Deck is moulded GRP,
stress areas where winches, sheet tracks, etc, are
reinforced by using backing chrome plates.
Ballast : 1900 kg. Cast iron, torpedo shaped bottom, end
keel bolts are of stainless steel.
Rudder : Glass fibre rudder on solid stainless steel stock (diam
50 mm. )
Rudder trunk stock is screwed to the skeg on the hull with
delrin housings.
Motor bed : Glass fibre bed moulded to the hull.
Chain plates : Stainless steel fixed on the hull.
Teak cockpit : Teak cockpit is laid from 10 mm. First class
teak ribs bonded to the deck with epoxy resin and secured by
stainless steel screws.
Expansion joints sealed by special polyurethane silicone.
Interior joinery : Marine grade water proof plywood faced
with selected mahogany or american cherry is used in all
bulkheads and major joinery. Specially selected solid
mahogany or beech in frames and doors. Marine plywood in
bottoms, shelves, etc. where not visible. All main bulkheads
bonded to hull and deck using glass mat and polyester.
Ceiling, top sides and visible hull sides padded with foam
backed vinyl. Hullsides, bottom, bilge, etc, topcoated
throughout the interior. Varnished cabin sole, mahogany with
ashtree inlaid wood stripes.
ACCOMODATION :
Forward cabin : Double berth , stowage under the berth ,
shelves along hullsides sb and port.
Saloon : -U- shaped settee on port side with fixed table.
Stowage under the settee.
Toilet compartment : GRP wash unit. Lockers along hullside,
moulded bottom section drained by electric pump.
Galley : Galley on SB side, ice-box with 12 v Danfoss
compressor, double sink, drawer section, dry food lockers.
Gas stove with oven. The ice-box is drained.
Navigation area : Large navigation table with stowage for
charts etc. Electrical master panel mounted in bulkhead
locker, navigation seat.
Aft cabin : Large aft cabin on SB side with double berth and
wardrobe. Shelves along hulside , stowage under the berth .
DECK EQUIPMENT :
-2 hatches , size 41
-6 aluminium framed windows.
-3 portlights 20 x 40, 2 portlights 25 x 50
-1 x 32 STA Harken winch , 2 x 40 STA Harken winches
- One organiser with 3 sheaves and triple rope clutch
-4 mooring bollards,
-2 aluminium genoa tracks with rails.
-1 main sheet track with slider and tag lines.
-Navigation lights.
-25 mm. dia. Stainless steel pullpit, pushpit and ladder.
-1000 w. Electric anchor winch.
-Solimar brand pedestal and stainless steel steering with
leather cover, compass and acceleration lever fitted on the
pedestal.
General; Bolts, nuts, washers and screws used for fastening
deck equipment are of stainless steel. Sealing used between
deck and equipment is polyurethane, silicone or specially
developed material.
INTERIOR EQUIPMENT :
Fresh water system : 220 liters water capacity chromium
tank with level meter. Pressurised water. Filler line from
deck. Tanks are ventilated. Shower arrangement in toilet
compartment. Double sink and wash basin drained either
through hull or to the waste water tanks by means of valves.
Hot water is optional extra. Waste water tanks and drainage
with grinding.
12 volt bilge-pump.
Toilet installation : Hand operated marine toilet with sea
water in take and outlet through ball valves. Waste holding
tank. Electric toilet is optional extra.
Shower : Shower basin is drained by electric drainage pump
operated by manual switch in shower compartment.
Cushions : Cushions in high quality foam with first class
upholstery in choice of colours.
Electrical installation : Switchboard and control panel in
navigators area. 2 reading lights in forward cabin,
1 spot light in toilet, 4 spotlights in main cabin, 1
navigators light, 1 spot light 1reading light in aft cabin,
2 x 90 amp.hrs marine batteries, 1 both contactor.
Gas system : 1 small gas bottle ( 4,95 liters-2,5kg.)
installed in separate, drained compartment on deck.
Reduction valve for low pressure system. 2 burner gas stove
.
General Hardware : Doors have marine locks. Locker doors
have brass push locks and are hinged
with chromium plated brass hinges.
General : Bolts, nuts, washers and screws are generally
stainless steel. Hose clamps are all stainless steel.
Through bottom fittings and other piping fittings are brass.
Hoses are reinforced flexible pvc polyethylene.
INNER STEERING: Optional extra.
ENGINE INSTALLATION :
Engine : 30 Hp. Yanmar Sail Drive diesel motor . 3 blade
fixed propeller.
Controls : Lever controller and instrument panel in cockpit.
Fuel : 120 litres diesel tank in stainless steel with level
meter. Filling from deck.
Engine housing : Easily removed engine room cover with
interior joinery finish, well insulated
with foam.
Battery : 2 x 90 amp.hrs battery with both contactor.
MAST AND RIGGING :
Main mast : Selden brand 12.5 m. long. Furling Mast
with two levels of spreaders, boom and
boomvang. Cenoa furler.
Standing rigging : All stays and shrouds in stainles steel
wire.
Running rigging : 1 main halyard, 1 cenoa halyard, 1 main
sheet, 2 jib sheets.
Sails : 1 main sail, 1 furling genoa , sail bags. (UK sails)
ELECTRONIC:
Autohelm brand, ST 40 deep sounder and speed indicator.
STANDART EQUIPMENT :
2 Mooring lines
4 Fenders
1 Anchor with chain.
1 Instruction manual.
|