EGE 35
DIMENSIONS :
Length overall :...... 10.35 m.
Length of waterline : 9.25 m.
Beam : ................... 3.50 m.
Draft :..................... 1.70 m.
Displacement :...... 6.100 kg.
Height Overall :...... 14.00 m.
Ballast : ...............1.900 kg.
Headroom : ............ 2.00 m.
Cabins :.................. 2 - 3
Berths :.................. 6 - 8
Toilets :.................. 1
Engine :.............. 30 hp YANMAR
Fuel Tank :.................... 90 lt.
Furling Genoa Sail :..... 32,50 m2.
Main Sail : ................... 23,10 m2.
Fresh Water Tank :...... 170 lt.
Black Water Tank :....... 80 lt.
Gray Water Tank :.........40 lt.
CONSTRUCTION :
Hull : Hand made solid laminate GRP mat and rowing.
Deck : Deck is moulded GRP, stress areas where winches, sheet tracks, etc,
are reinforced by using backing stainless steel plates.
Ballast : 1900 kg. Cast iron, torpedo shaped bottom, end keel bolts are of stainless steel.
Rudder : Glass fibre rudder on solid stainless steel stock (diam 50 mm.)
Rudder trunk stock is screwed to the skeg on the hull with delrin housings.
Motor bed : Glass fibre bed moulded to the hull.
Chain plates : Stainless steel fixed on the hull.
Teak cockpit settee : Teak cockpit bench is laid from 10 mm. First class teak ribs bonded to the deck with Sika.
Interior joinery : Marine grade water proof plywood faced with american cherry is used in all bulkheads and major
joinery. Specially selected solid breech in frames and doors. Marine plywood in bottoms, shelves, etc.
where not visible. All main bulkheads bonded to hull and deck using glass mat and polyester. Ceiling, top sides
and visible hull sides padded with foam backed vinyl. Hullsides, bottom, bilge, etc topcoated throughout the
interior. Varnished cabin sole, mahogany with ashtree inlaid wood stripes.
ACCOMODATION :
Forward cabin : Double berth , stowage under the berth , shelves along hullsides sb and port, 2 lockers on both
sides, 2 drawers on both side.
Saloon : Settee on both sides. Table with fixed middle section and folding wings. Stowage upper side of settee
on both sides.
Toilet compartment : GRP toilet compartment, locker on hullside, moulded bottom section.
Galley : -L- shaped galley with ice-box with 12 V Danfoss compressor, double sink, drawer section, dry food
locker, double overhead cupboards. 2 burner gas stove.
Navigation area : Large navigation table with stowage for charts etc. Electrical master panel mounted in bulkhead
locker, navigation seat.
Aft cabin : Large aft cabin on SB side with double berth and wardrobe. Shelves along hullside, stowage under the berth.
DECK EQUIPMENT :
-2 hatches, 5 portlight, 2 windows.
-1 x 32 STA Harken winch , 2 x 40 STA Harken winches
-One organiser with 3 sheaves and triple rope clutch
-4 mooring bollards,
-2 aluminium Harken genoa tracks with rails.
-1 Harken main sheet track with slider and tag lines.
-Navigation lights.
-25 mm. dia. Stainless steel pullpit, pushpit and ladder.
-800 W. Electric anchor winch.
-2 Solimar steering system with 2 stainless steel steering wheels Dia. 80 cm.with lorica cover, compass on cockpit table and acceleration lever fitted on deck SB side.
General; Bolts, nuts, washers and screws used for fastening deck equipment are of stainless steel. Sealing used between deck and equipment is polyurethane, silicone or specially developed material.
INTERIOR EQUIPMENT :
Water system : Water capacity 170 litres in GRP tanks. Pressurised water. Filler line from deck. Tanks are ventilated. Double sink and one wash basin is drained through the hull and other is drained to the waste water tank directly. Waste water tanks and drainage with 12 V pump.
Toilet installation : Hand operated marine toilet with sea water intake and outlet through ball valves. Waste holding tank.
Shower : Shower basin is drained by electric drainage pump operated by manual switch
in shower compartment (shower arrangement is optional extra)
Hot water is optional extra
Cushions : Cushions in high quality foam with first class upholstery in choice of colours.
Electrical installation : Switchboard and control panel in navigators area. 1 spot light and 2 reading lights in forward cabin, 1 light in toilet, 4 spot lights in main cabin, 2 spot light 1 reading light in aft cabin,
2 x 90 amp.hrs marine batteries, 1 both contactor.
Gas system : 1 small gas bottle ( 4,95 liters-2,5kg.) installed in separate, drained compartment on deck. Reduction valve for low pressure system. 2 burner gas stove with owen.
General Hardware : Doors have marine locks. Locker doors have brass push locks and are hinged with chromium plated brass hinges.
General : Bolts, nuts, washers and screws are stainless steel. Hose clamps are all stainless steel. Through bottom fittings and other piping fittings are brass. Hoses are reinforced flexible pvc polyethylene.
12 V bilge pump interior. Manual emergency bilge pump on cockpit area.
ENGINE INSTALLATION :
Engine : 30 HP. Yanmar diesel saildrive motor with 3 blade fixed propeller. Fresh water cooled.
Controls : Lever controller and instrument panel in cockpit.
Fuel : 90 litres diesel tank in stainless steel with level meter. Filling from deck.
Engine housing : Easily removed engine room cover with interior joinery finish, well insulated with foam.
Battery : 2 x 90 amp.hrs battery with both contactor.
MAST AND RIGGING :
Main mast : Selden brand 12.50 m. long. Mast with two levels of spreaders, boom and boomvang. Furlex genoa furler.
Standing rigging : All stays and shrouds in stainless steel wire.
Running rigging : 1 main halyard, 1 genoa halyard, 1 main sheet, 1 genoa sheets.
Sails : 1 main sail, 1 furling genoa and sail bags.
ELECTRONIC:
Autohelm brand, ST 40 deep sounder and speed indicator.
STANDART EQUIPMENT :
1 Instruction manual.
|
